Sound Reactive LED Matrix Led Panel

To use the LED Panel it must be set up on your home network and then can be controlled with any browser using the control panel for the LED Matrix.

1. Plug the LED Panel into the powr supply

2. Using phone, tablet or PC look at the available WiFi networks. Select the WLED-AR network and connect

3. If asked, enter password wled1234

4. When connected use browser to go to addreess 4.3.2.1

5. At the WiFi config screen enter your home WiFi SSDI and password

6. The LED Panel will disconnect and reconnect to yout home WiFi

7. Logon to the loacl WiFi router (usually address http://192.168.1.254/ or http://192.168.1.1/)

8. Find the IP address for the WLED connection (will be 192.168.1.<something>)

9. Set the router so that the same IP address is always used (different foe each router so look for something like DHCP assignment or IP Address assignment)

10. On a browser goto the LED Panel IP address (identified in step 8 above)

11. You will be logged onto the WLED Control Panel where you can select colours, paterns and change the config parameters.

12. Bookmark the page and call it something like LED Matrix so that you anc find it again.